|
DESCRIPTION: |
| BUMPER WELD is a two
component, 100% solids, non-abrasive, high modulus epoxy
gel. It is used to adhere parking bumpers to concrete
and other like substrates. BUMPER WELD is supplied in
easy-to-mix 1:1 by volume ratio and is color-coded to
assure that mixing is complete.
BUMPER WELD - 30 -
Standard set, hand mixing.
BUMPER WELD - 5 - Rapid
set, use with meter mix pumping equipment, or is
packaged in easy-to-use two component cartridges. |
|
USES: |
| Adhere pre-cast
concrete parking bumpers.
Bonding hardened
concrete and other materials to hardened concrete. |
|
ADVANTAGES: |
| Moisture insensitive -
may be applied to dry or damp concrete or in humid
conditions.
Color-coded for
error-free mixing.
100% solids, conforms to
VOC regulations. No mechanical anchors or fasteners
required. Superior sheer strength to concrete and
asphalt. |
|
SURFACE
PREPARATION: |
| All concrete surfaces
to be bonded should be dry for best results. However, a
damp surface dry condition is acceptable. Surfaces must
be free of standing water. The substrate must be clean
and free of oil, grease, coatings and any other
contamination. |
|
MIXING
AND APPLICATION: |
|
Mix
thoroughly, 1 part of Component A with 1 part of
Component B by volume. Product should be a homogeneous
gray with no black or white streaks |
|
LIMITATIONS: |
| Do NOT allow the
product to freeze.
Do NOT apply when
temperature is below 50°F.
Do NOT apply to latex
modified mortar or concrete. |
|
CLEAN
UP: |
| Clean tools and
equipment immediately with a suitable solvent such as
xylene or lacquer thinner. |
|
PACKAGING: |
| 2 component cartridges
2 gallon units
10 gallon units
100 gallon units
|
|
CAUTION: |
| For professional use
only. Epoxy systems can cause delayed dermatitis. Avoid
prolonged contact with skin. See Material Safety Data
Sheet for proper handling and required safety equipment. |
| |
|
PROPERTIES
AT 77°F
| |
Bumper Weld-30 |
Bumper Weld-5 |
| Pot
Life (100 Grams) |
30-45
minutes |
5-10
minutes |
|
Compressive Strength (ASTM D-695) |
>10,000 psi |
>10,000 psi |
| Tensile
Strength (ASTM D-638) |
>8,000 psi |
>8,000 psi |
|
