|
DESCRIPTION: |
| SUPERIOR
SAW CUT FILLER 132 is a medium viscosity, rapid set,
100% solids liquid epoxy for filling saw cut grooves in
concrete. SUPERIOR SAW CUT FILLER 132 is designed for
use with meter mix pumping equipment or may be packaged
in easy to-use two component cartridges. |
|
USES: |
| Rapid set
filler and sealer for saw cut grooves.
Grout for dowel bars,
rebars and anchor bolts in concrete. |
|
ADVANTAGES: |
| Very rapid
set for early strength.
Moisture insensitive -
may be applied to dry or damp concrete or in humid
conditions.
100% solids, conforms to
VOC regulations. |
|
SURFACE
PREPARATION: |
| All
concrete surfaces to be bonded should be dry for best
results. However, a damp surface dry condition is
acceptable. Surfaces must be free of standing water.
Mechanical scarifying to remove laitance or other
foreign materials will result in optimum bond. Saw cuts
must be air blasted to remove residual dust. |
|
MIXING
AND APPLICATION: |
|
The
individual components should be mixed prior to combining
them or charging them into the compartments of
dispensing equipment. Check dispensing equipment to be
sure of correct 1:1 by volume mix ratio. If mixing by
hand, combine part A and part B in equal volumes. Do not
mix more material than can be applied in 5 minutes. Fill
saw cuts to the top or slightly higher than the
surrounding surface. A second pass prior to curing may
be necessary due to the fact that all pour grade
materials will "dish" or become concave. |
|
LIMITATIONS: |
| Do NOT
apply when temperature is below 33°F.
Do NOT apply to latex
modified mortar or concrete. |
|
CLEAN
UP: |
| Clean tools
and equipment immediately with a suitable solvent such
as xylene or lacquer thinner. |
|
PACKAGING: |
| 2 component
cartridges
2 gallon units
10 gallon units
100 gallon units
|
|
CAUTION: |
| For
professional use only. Epoxy systems can cause delayed
dermatitis. Avoid prolonged contact with skin. See
Material Safety Data Sheet for proper handling and
required safety equipment. |
| |
|
PROPERTIES
AT 77°F |
| Mix ratio by volume |
1:1 |
| Color |
Clear - Straw |
| Pot Life (100 Grams) |
5-10 minutes |
| Compressive Strength
(ASTM D-695) |
9500 psi |
| Tensile Strength (ASTM
D-638) |
7500 psi |
| Water Absorption |
0.13% |
| Coverage |
231 cubic inches per
gallon |
| Shelf Life |
1 year |
