|
DESCRIPTION: |
|
SUPERIOR GRIP is a 100%
solids, three component epoxy compound. SUPERIOR GRIP
produces a highly skid-resistant surface with silicon
carbide granules on dry and damp surfaces. |
|
USES: |
|
SUPERIOR GRIP is used
on areas where slippery conditions exist such as ramps,
stairs, walkways and docks. SUPERIOR GRIP may be used to
protect floors against water, chemicals and heavy
traffic. |
|
ADVANTAGES: |
| 100% solids, no VOC.
Epoxy liquids are mixed
in easy to use 1:1 by volume ratio.
Non-skid aggregate is
extremely hard and skid resistant
Excellent water and
chemical resistance.
May be applied to damp
surfaces and under high humidity conditions.
|
|
SURFACE
PREPARATION: |
| Concrete Surfaces
must be clean, sound, dry and free of all foreign
materials such as oils, grease, loose paint, dust and
laitance. This may be accomplished by sand blasting or
scarifying, followed by an air blast to remove dust and
debris from the application area. New concrete surfaces
should be acid etched, rinsed thoroughly and allowed to
dry.
Steel Surfaces
should be sand blasted to SSPC SP-10 near white. Water
blast or mechanical abrading is an alternative method,
as long as all rust, scale, paint and other foreign
materials are removed. Steel must be coated the same day
as cleaned.
Wood Surfaces
should be roughened by sanding. |
|
MIXING
AND APPLICATION: |
| 1. Stir parts A & B
2. Add contents of parts
A & B to mixing bucket supplied.
3. Mix thoroughly, being
sure to scrape the sides and bottom with the mixing
paddle supplied.
4. Apply to floor
immediately after mixing by pouring the mixed material
over the surface and spreading it uniformly with a
brush, roller, or notched trowel @ 100 square feet per
unit Mixed SUPERIOR GRIP has a working time of 30-45
minutes @ 75°F.
5. Sprinkle silicon
carbide granules evenly over the surface before coating
starts to set (within 30 minutes)
6. If less than unit
quantity is to be applied, mix liquid components in a
1:1 ratio by volume and spread @ 100 square feet per
gallon. |
|
LIMITATIONS: |
| Do NOT apply when
temperature is below 50°F.
Do NOT apply to latex
modified mortar or concrete.
Do NOT place over
working control joint. |
|
CLEAN
UP: |
| Clean tools and
equipment immediately with a suitable solvent such as
xylene or lacquer thinner. |
|
PACKAGING: |
|
25 lb units covering
100 square feet |
|
CAUTION: |
| For professional use
only. Epoxy systems can cause delayed dermatitis. Avoid
prolonged contact with skin. See Material Safety Data
Sheet for proper handling and required safety equipment. |
|
PROPERTIES
AT 77°F
| Pot Life (100
Grams-neat) |
30-45
minutes |
| Color |
Black |
| Mix Ratio (Liquids) |
1:1 by volume |
| Coverage |
100 sq. @ 16 mils/ 25
lb. unit |
| Initial Cure |
6-8 hours |
| Chemical Resistance |
Excellent against
water, most alkalies, and aliphatic hydrocarbons. Good
against mild mineral acids. Fair against organic acids
and methanol. |
| Shelf Life |
2 years |
|
