|
DESCRIPTION: |
|
SUPERTOP is a
structural epoxy mortar topping which provides
hard-surfacing, skid proofing and corrosion protection
of either new or eroded old concrete floor surfaces.
SUPERTOP cures to an "industrial" tough, chemical and
wear resistant surface. SUPERTOP will provide protection
against spillage of most acids, alkalies, fats, oils,
sugars and other damaging substances. |
|
USES: |
| Surfacing and patching
concrete floors.
Skid resistant
surfacing.
Chemical resistant
flooring. |
|
ADVANTAGES: |
| Physical properties far
exceeding those of concrete.
Easy-to-use pre-measured
kits.
100% solids - no
shrinkage.
Excellent abrasion
resistance
Seamless, slip resistant
and easily cleaned.
Available in standard,
low temp and chemical resistant versions. |
|
SURFACE
PREPARATION: |
|
Surface must be clean,
sound, dry and free of any oils, grease, curing
compounds, dust, laitance or any other contaminants.
This may be accomplished by sand blasting, water
blasting or some other mechanical means. New concrete
surfaces should be acid etched with muriatic acid and
rinsed thoroughly. Surface may be dry or damp, but must
be free of standing water. |
|
MIXING
AND APPLICATION: |
| 1. Pour contents
of Binder Part A and Part B into empty pail and mix
thoroughly with spatula or a slow speed 1/2" drill with
paddle. 2.
Add aggregate slowly, while mixing, to the mixed binder.
3. Mix until
aggregate is thoroughly wet, approximately 2 minutes.
4. Apply to
prepared surface with a trowel. |
|
LIMITATIONS: |
| Do NOT apply when
temperature is below 50°F.
Do NOT apply to latex
modified mortar or concrete.
Do NOT use on floors
subjected to constant temperatures in excess of 180°F. |
|
CLEAN
UP: |
| Clean tools and
equipment immediately with a suitable solvent such as
xylene or lacquer thinner. |
|
PACKAGING: |
|
Kit contains binder and
blended aggregate in plastic 5 gallon mixing container.
Kit covers for 35 square feet @ 1/8". |
|
CAUTION: |
| For professional use
only. Epoxy systems can cause delayed dermatitis. Avoid
prolonged contact with skin. See Material Safety Data
Sheet for proper handling and required safety equipment. |
|
PROPERTIES
AT 77°F
|
|
Available in several
different types- See Technical Bulletin for physical
properties of type selected. |