|
The Superior Trac System is a multi-layer, seamless, epoxy
based floor surfacing system that is installed at a depth
of 3/16" to 1/4" of an inch. It is then topped with an
epoxy quartz broadcast system. Superior Trac is then
sealed with a topcoat to improve abrasion resistance,
gloss retention and non-skid properties. Superior Trac is
a skid-resistant and easy to maintain flooring system that
provides protection from wear-resistance and damaging
substances. Superior Trac offers a safe yet cleanable
floor surface. |
|
Superior
Epoxy Primer 171
Mix 1 volume of part A with 1 volume of part B. Mix
thoroughly, being sure to scrape the sides and bottom with
a strong mixing stick or a slow speed drill with a paint
propeller attachment. DO NOT mix more than can be applied
in 20 minutes. Apply mixed material by brush, roller or
squeegee at 150 to 200 square feet per gallon (8-10 mils).
The coverage will depend on the texture of the surface.
Apply toppings before primer becomes tack-free,
approximately 2-3 hours at 72°F.
Superior TopMortar
Mix thoroughly 2 parts by volume of part A and 1 part by
volume of part B of Superior Liquid Binder. Prepare the
mortar by adding 3-3 1/2 gallons of clean, dry sand to
each gallon of epoxy mix. Preferred types of sand are:
hard, high-grade silica sands such as Ottawa Flintshot,
Mission or their equivalents. Emery or other forms of
Alumina, and Silicon Carbide. If a blend of sand is used,
mix the sands together prior to adding to the epoxy. Blend
the epoxy and sand until the sand is thoroughly wet.
Screed the mortar out onto the previously primed area,
rake it to distribute, then compact and trowel to finish.
Blending may be accomplished by using a heavy duty, slow
speed 1/2" electric drill with a paddle, a Kol mixer or a
mortar pan and concrete
hoe.
Superior
Quartz Binder
Mix 1 volumes of part A with 1 volume of part B. Mix
thoroughly, being sure to scrape the sides and bottom with
a strong mixing stick or a slow speed drill with a paint
propeller attachment. DO NOT mix more that can be applied
in 20 minutes. Apply mixed material with a notched
squeegee at 90-110 square feet per gallon. Back roll
quartz binder. After curing, sweep un-adhered excess
aggregate from surface. For a higher build, repeat
application of quartz binder and aggregate.
Seal Coat
To apply the seal coat of
Superior Gloss over the
broadcast: stir each component separately. Clear: Mix 2
volumes of part A with 1 volume of part B. Pigmented: Mix
1 volume of part A with 1 volume of part B. Mix
thoroughly, being sure to scrape the sides and the
bottom, with a bottom, with a strong mixing stick or a
slow-speed drill equipped with a paint propeller. DO NOT
mix more than can be applied in 30 minutes. As a coating,
apply mixed material by brush or roller. For best results,
two coats should be applied. Allow the first coat to cure
overnight. Apply the second coat within 24 hours. If more
time than 24 hours has elapsed, a light sanding of the
first coat is required. Superior Gloss can be placed a
thick as desired on horizontal surfaces without affecting
the cure
*** When
chemical-resistance is needed substitute
Superior Novalac
for Superior Gloss ***
|
